![]() The top of the switch is ground so do not bridge the pad with the top.Īlso from past experience, be very careful with flux around this area since the switch is very sensistive and not air tight. I think I used around 9 inches of wire and then cut it to length when I was done. ![]() I use the tweezer tips on the little tab and alternate between each side moving it straight out the connector a bit at a time.ĭo not pull by the wire Also, be careful, Im sure there is high voltage here (feels like a tazzer if you do).Īlso notice the distance between this half and the body since this is how much slack you will need in your wire leads if you mount the jack where I did. You do not need to remove the scew below the 14 - 20 tripod mount nor on the screen. This prevents me from leaving out a screw or forgetting where they go and what size goes where. Its also a good time to take out the battery and put down a lint free towel to work on. ![]() Sony Nex 5N Hacked Firmware Free Towel To The mod is a lot easier than the Sony NEX-5 but it takes just as much time to make it look pretty. This jack will allow you to fire a NEX-7 continuously and precisely with an external pocket wizard, tongue switch, timer, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |